Expert Answers about Jayco Eagle Fifth Wheel

• Lippert Ground Control 3.0 Touch Pad Displays "Please Wait And Then Turns Off
• I spoke to Lippert and they said to check a few things. First, they did say to double check the battery and make sure it is not dropping under 12 volts. The system will always draw from the battery, even when attached to shore power, and the controller needs to stay constant. They mentioned that a common cause of this will be a ground issue. The green wire will be the ground so you will need to make sure this has a solid connection and not stacked with other grounds. The black wire will...
  view full answer...


• Troubleshooting No Signal With A Furrion Vision S RV Camera System
• If your Furrion Vision S Camera System # FOS43TASF is getting power and still not connecting then it most likely isn't receiving enough power. The camera system requires a constant 12 volts to operate and depending on the vehicle you're towing the trailer with you could potentially have PWM wiring. PWM wiring provides a flickering power source which will allow the camera to turn on but not fully function. The solution is to splice the PWM Filter # VGR64VR into the wiring behind the camera....
  view full answer...


• Replacement Wiring Harness for Solera SmartArm Awning for Rain Sensor
• We have a replacement wiring harness for the Solera SmartArm awnings with the part # LC56ED but if your current awning does not have correct connectors for use with the rain sensor part # 919061654 it is possible you don't have correct awning to add the rain sensor to.
  view full answer...


• Troubleshooting Display of Lippert Ground Control 3.0 RV Leveling System
• Are any messages showing on the control panel? According to Lippert there should be an error description on there if there's a problem. Typically, the blinking orange lamp indicates which jack is the low spot. If the control panel is blank, Lippert recommends unplugging the panel for a minimum of 15 minutes. When you plug it back in, the panel should reset. If there's still a problem at that point, get back with us and we'll pursue it further with Lippert.
  view full answer...


• No Signal to Furrion Camera FOS05TASF
• Thank you for your purchase from etrailer of the Furrion Vision S Camera System # FOS05TASF. According to Furrion there are a number of things you can do to try to remedy the situation if you are not getting a signal, to start you should check if the camera antenna is fitted and secured correctly, as it should be vertical. It could also be that the distance between camera and monitor is too great so if possible reduce that distance. There may be interference from electrical appliances...
  view full answer...


• How to Test a 7 Way Trailer Plug
• If the 7 Way Trailer Plug was installed upside-down, it definitely could have shorted something out. Using something like the circuit tester # PTW2993, you will first need to check all the ports on your 7 Way vehicle side plug. The 2 o'clock position will be your 12-volt power, the 3 o'clock position will be the right turn signal and right brake signal, the 5 o'clock position will be your brake controller output, the 7 o'clock position will be your ground, the 9 o'clock position will be...
  view full answer...